Created by-Lamont Philipsen
Are you doing your own plumbing for the first time? You probably don’t even know where to start. It’s no secret that doing your own plumbing for the first time can be a bit overwhelming. Below are some tips that can help to make maintaining your own plumbing a bit smoother.
Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.
The next time you have a clogged drain, avoid the simple solution of dumping drain-clearing chemicals into the pipes. While this method involves the least amount of effort, the chemicals in these liquid cleaners are destructive to your piping. Instead, consider using a little bit of elbow grease with a plunger, snake, or other device designed to clear your clog without chemicals.
If your pipes are prone to freezing, let the water trickle continuously in at least one faucet during weather that is below freezing. This will minimize the chances that the pipes will freeze and leave you without water. If water is continually running through the pipes and trickling out of a faucet, the pipes are less likely to freeze.
Making sure you know all of your problems so you can have them fixed by one plumber visit is very beneficial. Having them all fixed in one visit takes a lot of money off of your bill because you don’t have to pay for the visit multiple times so make sure you make a list first.
Don’t put oil, grease or fat into your drain. This is a certain way to either slow your drainage or clog your drain entirely. This can make your garbage disposal run slower. To keep your drain running efficiently, dispose of fats and oils in other ways besides pouring them down the drain.
You can easily see if there are any serious damages caused by leaks by checking if the floor is soft around toilets. Straddle the toilet and rock from one foot to the other to see if you feel any weakening or “softness” in the floor beneath you. diy plumbing advice can save money by noticing and treating this problem as early as possible.
Watch how your toilets are flushing. If you have to jiggle the handle or if it takes too long, you might have to repair some toilet parts. Replacing these parts early may help you to save on your water bills and will save you from more expensive repairs at a later date.
If the hot water heater in your house is over ten years old, you should look at replacing it. Hot water heaters are very susceptible to corrosion on the bottom. This can lead to leaking and flooding whatever room it is in. Then not only will you have to replace it, but you’ll have to fix any damage caused by the leak.
Try to limit the amount of hair that goes down your drains. Hair can become tangled up in the pipe and end up blocking up the them, preventing water from flowing smoothly. Buy a cheap screened drain cover to put over your drain to stop any hair from going down and clean it off regularly.
Do a routine check around your house each month on each and every faucet to make sure there are no signs of leaks or drips. Over time, leaks can add a lot of money to your water bill and will worsen if you do not take care of the problem.
Many people complain of low water pressure. While there are several things that can cause this, one must not be overlooked when starting your investigation. What kind of pipes do you have? If your piping is galvanized, you are better off just replacing your piping which will eliminate the issue.
If you install a new water heater, and you start to have a leak from the pressure relief valve, you may need an expansion tank installed. The pressure increases when the functioning of the water heater is being performed properly. Therefore, with your new water heater, it may be necessary to have an expansion tank as well.
If you have a leak and your water bill is going up, there is a method you can try before you call a professional. You can use the red-dye system to detect whether the leak is above ground, underground, or whether it has anything to do with the toilets.
Remember that there is https://www.seattletimes.com/explore/at-home/pro-tips-for-hiding-pipes-and-ducts-in-your-walls/ to plumbing than simply knowing that water runs downhill. One of the most common things that a plumber works on is fixing water lines.
It is imperative as a homeowner that you know exactly where your main water shut-off valve is located and can operate the valve in case of an emergency. The best first step measure for frozen pipes is to stop water from entering your home in the first place. Locate the main water supply valve and turn it on and off on a regular basis to keep it easily operable in an emergency.
It is important to clean your faucet’s aerator from time to time. Not cleaning it can cause lime buildup, which in turn, could cause water leaks or low water pressure. To clean a aerator, you can unscrew it from the faucet, dip a brush into vinegar, and use the brush to clean it.
If you drop a small item like a ring or earring into a sink drain, hope is not lost. By carefully removing the U-shaped trap underneath the sink, you can probably retrieve the item. Be aware that the trap will be full of water, though, so have something under it to catch the spills.
There is no doubt that many of the common maintenance and repair jobs that need doing on your plumbing are things that you are well capable of. You just need to adopt a cautious and methodical approach. Don’t rush anything or take chances and you’ll be fine. And, if you’re a husband, you can score major brownie points with your wife!